Heated Oxygen Sensor Replacement - Sensor 2 - Chevrolet Aveo 2009 Service Manual

Document ID: 2098054
|
2009 Chevrolet Aveo Aveo, Wave, G3, Barina (VIN S/T) Service Manual

Heated Oxygen Sensor Replacement - Sensor 2

Removal Procedure
Warning: Refer to
1. Disconnect the negative battery cable.
Caution: Refer to
Caution: Do not solder heated oxygen sensor wires. Soldering the wires will result in the loss
of the air reference to the sensor. Refer to Engine Electrical for proper wire and connection
repair techniques.
2. Disconnect the electrical connector.
3. Remove the heated oxygen sensor 2 (HO2S2).
Installation Procedure
http://localhost:9001/si/showDoc.do?docSyskey=2098054&pubCellSyskey=124944&pubO...
| | Document ID: 2098054
Repair Instructions
Battery Disconnect Warning
Heated Oxygen and Oxygen Sensor Caution
© 2010 General Motors Corporation. All rights reserved.
| |
Engine Engine Controls and Fuel - 1.6L (LXT)
in the Preface section.
in the Preface section.
Page 1 of 2
7/5/2010