Table of Contents
Advertisement
Document ID: 2098053
Note: A special anti-seize compound is used on the oxygen sensor threads. This compound
consists of a liquid graphite and glass beads. The graphite will burn away, but the glass
beads will remain, making the sensor easier to remove. New or service sensors will already
have the compound applied to the threads. If a sensor is removed from any engine and if for
any reason it is to be reinstalled, the threads must have anti-seize compound applied before
reinstallation.
1. Coat the threads of the HO2S1 will an anti-seize compound, if needed.
Caution:
Refer to
2. Install the HO2S1 to the exhaust manifold using
Tighten
Tighten the oxygen sensor to 42 N·m (31 lb ft).
3. Connect the HO2S1 connector.
4. Connect the negative battery cable.
http://localhost:9001/si/showDoc.do?docSyskey=2098053&pubCellSyskey=124943&pubO...
Fastener Caution
in the Preface section.
EN-46577
.
Page 2 of 2
7/5/2010
Hide quick links:
Advertisement
Table of Contents
