Activation; Setup And Calibration; Customizing The Foam Rubber Cut-Out (Passepartout) - Omegon Universe2go Instructions Manual

The planetarium mode requires the
input of a ten-digit code that can be
found on the inside of the product
package.
This code is requested only once when
first starting the planetarium mode
and requires an internet connection
for activation.
The star-map mode can be used
without an activation code.

2. Setup and calibration

Universe2go can be used with a vast
variety of smartphones with different
dimensions, screen sizes, number of
pixels and pixel density.
Note: System requirements can be
found at the end of this operating
manual. [page 24]
6
Note: The gyroscope, compass,
geolocation, microphone and sound
must all be activated, both in your
Smartphone and in the Universe2go
app (iPhone) .
For this purpose, Universe2go must
first be set up on your smartphone.
The number and variety of smart-
phones currently available on the
market is almost inestimable and we
have spent a lot of time and effort to
make the setup procedure as simple
and reliable as possible. Therefore
please take care during initial setup
and, if necessary, refer to online
help under www.universe2go.com
under the menu option "CUSTOMER
SERVICE".
2.1 Customizing the foam rubber
cut-out (passepartout)
The passepartout must first of all be
customized to the smartphone.
A. Open the lid and remove as many
foam rubber parts as necessary to
be able to fit the smartphone loosely.
[fig. 1]
B. To secure the smartphone in place,
stick a large triangle in the left upper
corner (the device is placed in viewing
direction in front of you) and a small
triangular piece of foam in the top
right corner.
With some models, a different
arrangement of the foam pieces may
be required, while other models require
extra care that no control button on
the smartphone is pressed during use.
Place the triangles in such a way that
the smartphone fits tightly, but can still
be easily removed and installed when
required. [fig. 2]
C. First, check the fit without removing
the adhesive foil from the triangles.
To test the fit, you may close the lid
and carefully shake the device, during
7