Mounting - Johansson proflex 5500 User Manual

5500 ProFlex

1.6. Mounting

Proper installation is critical to system performance. It is particularly important to
install the ProFlex correctly in order to receive optimal signal quality.
Install the ProFlex in a well ventilated and cool room. In case the ambient
-
temperature of the room is higher than 30°C (or 91°F), the ProFlex must be
used in combination with a fan unit (Ref. 5062ETH).
Slide the ProFlex in a 19 inch DMH rack (Ref. 5065ETH). screw 4 bolts in the
-
front plate of the ProFlex to secure it to the DMH rack.
Plug the 4 satellite cables in the Satellite in ports. If applicable, loop the
-
satellite signal through to the next module using the RF bridges. If not
applicable, insert a 75 Ohm terminator in each Satellite out port.
If the ProFlex should receive RF signal from a previous module in the rack,
-
plug the 125mm coaxial cable in the RF in port.
If the ProFlex is configured to read CAM cards, insert 1 or 2 CAM cards* and
-
smart cards* in the slots on the backside of the ProFlex. (*Not included with
the ProFlex).
Depending on your video communication network: If video communication is
-
over IP network: plug an Ethernet cable in the streaming port and insert a 75
Ohm terminator in the RF out port. If video communication is over coaxial
network: insert a coaxial cable in the RF out port.
Connect the ProFlex to the power supply unit (Ref. 5051ETH or 5051UKETH)
-
(power + GND) using the DC banana bridges. If applicable, also connect the
ProFlex to the next module in the rack, making sure they are powered as well.
Once it is powered, a
the LED stops blinking and turns BLUE, the module is completely booted and
ready for configuration. This will take approximately 4 minutes.
For configuration of the module, plug one end of the Ethernet cable in the
-
control port, and the other end in a computer (to access the webinterface) or in
a remote control unit (Ref. 5950) (to remotely access the Universal User
Interface).
More information about configuration of the ProFlex module can be found in
-
the next section
RED LED above the control port will start blinking. When
6