Device Configuration; Input - Johansson proflex 5500 User Manual

5500 ProFlex

DEVICE CONFIGURATION

It is of utmost importance that your device is configured in a right way in order to make the
ProFlex installation successful. To do so, follow the below mentioned steps carefully.

1. Input

1.1 Define the LNB settings (INPUT > LNB > INPUT 1-4)
o Input: Sequence number of the input (also indicated on the front
of the actual module)
o Label: custom label for each input (e.g. VLow, or ASTRA
19.2VLow, ...)
o Voltage: The LNB voltage to select the polarization
13V: Vertical polarization

18V: Horizontal polarization

o Tone: LNB tone to select low/high band
ON: high band

OFF: low band

o DiSEqC®: control of a DiSEqC® switch (A/B/C/D)
o Band: Satellite band
Ku-band

C-band

o Extended Voltage: Add 1V to the LNB voltage to compensate the
cable losses for long coaxial cables.
o Enable: do not forget to enable the LNB input, this is disabled by
default)
Press APPLY
o
to confirm the parameters.
11