Cam - Johansson proflex 5500 User Manual

5500 ProFlex

3. CAM

3.1 Set the CAM configurations for the ProFlex (CAM > CAM 1-2)
o Only do this if you use a ProFlex module with the CAM feature
enabled
o Type: To prevent network overflow, it is important to choose the type of
the CAM (this can be found on you CAM-card:
Low-speed (legacy CAM) up to 50 Mbps

High-speed (modern CAM) up to 100 Mbps

o Watchdog: The watchdog monitors the scrambling status of all services
going through the CAM. In case one or more service sare no longer
descrambled, the watchdog will proceed to the reset of the CAM module
to try to restore the descrambling of the service(s). Activate this feature
only once all services are properly descrambled by the CAM module.
o Reference Transponder:
transponder in the CAM menu (for each CAM individually). The CAM
module needs authorization to descramble services. Select the reference
transponder with authorization information for each CAM individually.
o Press APPLY to confirm the parameters.
It is necessary to enable and select a reference
17