Johansson proflex 5500 User Manual page 13

5500 ProFlex
1.2 Define the settings for each of the 8 tuners (INPUT > TUNER >
TUNER 1-8)
o Input: this refers to the LNB inputs; make sure the transponder
frequencies you choose correspond to the right polarity of the LNB
inputs
o Frequency: choose the frequency of the transponder you want to
receive
o Baud Rate: choose the baud rate of the transponder signal you want to
receive
o Modulation: choose between DVB-S and DVB-S2
o Enable: click the tick box to enable the tuner
default)
o Check the lock status, signal level, signal quality and signal to Noise in
the top right of the window to see if the tuner locks on the selected
transponder
o Press APPLY to confirm the parameters.
o The module will now set the tuner to this frequency. Wait until the
correct parameters are loaded. When the tuner is able to lock on
the frequency, the services status from this transponder will be
shown in the top right corner.
(this is disabled by
12