Buypass Configuration For Rapid Connect - VeriFone Commander Site Controller Configuration Manual

BuyPass Configuration for Rapid Connect

Before beginning a network conversion to Rapid Connect, close out the
daily reports for any transactions run on the current network
configuration.
To ensure proper configuration of the Verifone Viper EMV Solution, the
merchant's First Data profile must be set to allow for Rapid Connect~EMV
processing. Contact the First Data Merchant's Helpdesk for assistance.
The table below shows the configuration parameters that will be modified for
conversion to Rapid Connect.
Review the information and proceed to the next page for further instruction.

Payment Controller>EPS Configuration>BuyPass Configuration
Network
Communication
Options
(Non-Datawire Only)
FEP Parameters
Security
(Datawire Only)
Communication Options address values may need to be updated
for proper Rapid Connect setup. Addresses are provided by the
Payment Host. Refer to the client's Network Configuration Guide
for additional information.
BuyPass Codec
Dealer ID
Terminal ID
Domain Name
Port
Brand
Datawire Secure
Channel
Web Address
Allow Registration
5
UMF
6-digit Rapid Connect Merchant ID.
3-digit Terminal ID.
Provided by Payment Host.
Provided by Payment Host.
BUYPASS (or major oil brand selection)

Enabled
https://prod.dw.us.fdcnet.biz/sd/srsxml.rc
Enabled 