Cisco TelePresence Manual page 12

CUCM Integration with Content Server 6.2
Route List Configuration
A route list associates a set of route groups in a specified priority order. A route list then associates
with one or more route patterns and determines the order in which those route groups are accessed.
The order controls the progress of the search for available devices for outgoing calls.
A route list can contain only route groups.
Each route list should have at least one route group. Each route group includes at least one device,
such as a gateway, that is available. Based on device type, Cisco Unified Communications Manager
can choose some, or all, ports as resources in each route group. Some devices, such as digital access,
only allow you to choose all ports.
A Route Group can be added to any number of Route Lists.
The following procedure describes how to configure a route list:
Step 1
Choose Call Routing > Route/Hunt > Route List.
Step 2
Click Add New.
Step 3
In the Route List Name field, enter a name. The name can comprise up to 50 alphanumeric characters
and can contain any combination of spaces, periods (.), hyphens (-), and underscore characters (_).
Ensure that each route list name is unique to the route plan.
Step 4
From the drop-down list box, choose a Cisco Unified Communications Manager group.
Note
The Route List registers with the first Cisco Unified Communications Manager in the group which is its
primary Cisco Unified Communications Manager.
Note
If you choose a Cisco Unified Communications Manager group that has only one Cisco Unified
Communications Manager configured, you receive the following warning:
The selected Cisco Unified Communications Manager Group has only one Cisco Unified
Warning
Communications Manager configured. For the control process to have redundancy protection,
please select a Cisco Unified Communications Manager Group with more than one Cisco Unified
Communications Manager
Step 5
Click Save.
Note
A popup message reminds you that you must add at least one route group to this route list for it to accept
calls.
The Route List Configuration window displays the newly added route list.
Step 6
By default, the system checks the Enable this Route List check box for the new route list.
Note
If you want to disable this route list, uncheck this check box. A popup window explains that calls in
progress are not affected, but this route list will not accept additional calls.
Step 7
Add at least one route group to the new route list.
Cisco TelePresence Content Server Release 6.2.1 Administration and User Guide
3-26
Chapter 3 Configuring a Cisco Unified Communications Manager SIP Trunk with a Cisco TelePresence