Table of Contents
Advertisement
Operating Instructions
Inspection
Carefully unpack and inspect your burnisher for shipping damage. Each unit is tested and thoroughly inspected
before shipment; any damage is the responsibility of the delivery carrier who should be notifi ed immediately.
Electrical
This machine is battery operated and designed to operate on 36 volts DC (3) 12 volt batteries.
Batteries
Burnishers are shipped with batteries. (3 required)
Part No. 956210 12V 210AH 20 Hr. Rate
We do not recommend mixing AMP hour capacities. Any alternate battery sets can be used if they equal physical
size and capacity. See next page for service and installation.
Operation
Before starting, familiarize yourself with the machine and its controls (see "Machine Overview" and "Dashboard
Control Panel" diagrams). To turn the machine ON, do the following:
1. Make sure 20" high speed pad is used. Make sure the pad is installed on the machine by following instructions
under "Pad Installation."
2. Make sure that no battery charger is plugged into the recharge port.
3. Lift the red emergency disconnect button so it is in the up position.
4. Lower the pad driver assembly by pushing the pedal slightly outward on the machine (unlock it), and then
release it slowly.
5. Turn the key switch to the ON position. The pad driver will then slowly adjust itself to the fl oor. Make sure the
machine is set to move forward indicated by the light on the dashboard control panel.
6. Place hands on the bails and squeeze the bail levers to start the operation of the machine. Move forward in a
straight line, check the reading on the Operating Range Meter and make sure you are in the Green Zone.
7. Adjust the pad pressure as needed by turning the knob accordingly. (See Pad Pressure Adjustments.)
8. Adjust speed as needed by turning the speed control knob accordingly.
Lumina 20 Traction Drive Battery Burnisher
Page 6
Advertisement
Table of Contents
