Configuring The Ethernet; Security Measures For Your Wireless Lan - Funkwerk W1002 Manual

Configuring the Ethernet

Security Measures for your Wireless LAN

1-12
The number of the available channels is not identical for all
device generations. You should, therefore, also refer to the
current data sheet for your funkwerk Wx002. As a rule,
however, channels 1 to 11 are available.
In the case of devices where the factory default setting is
not "Auto_DFS", the preset parameter for port wl1 is
channel 1 with 2412 MHz, i.e. 2.412 GHz. The preset value
for port wl2 is channel 11 with 2,462 MHz.
6. Select the desired frequency by using the arrow keys and
confirm by pressing Enter.
With the basic configuration of the ComPoint Manager, you have
already configured the IP address, the subnet mask, and the gate-
way for the funkwerk Wx002.
You will find further parameters for configuring the Ethernet port
under Config > Ports > <Ethernet Port> (e.g. eth1).
These parameters are:
• Interface
• Auto neg mode
• Actual value
You will find the description of the individual parameters in
Section Config > Ports > Port <Ethernet Port>, Page
In order to prevent unauthorized access to your wireless LAN, you
ought to take the following measures:
The Basic Configuration
4–24.