Connectors - Toshiba ST-70 SERIES Owner's Manual

3. CONNECTORS

3. CONNECTORS
CAUTION!
Do not press the Reset Switch unnecessarily. Doing so may cause an error.
Power Switch
Power Switch ..................... Push-button power switch
FDD Connector .................. Connector for the optional FDD unit
Reset Switch ...................... Pressing this key at the time of a hung-up resets the unit.
Brightness Control ............. Brightness of the operator's display is adjusted by using a jeweler's screw
LAN LED ............................ Operating status of the LAN is indicated.
USB 3................................. Connector for the USB (Universal Serial Bus) interface
PC Card Interface Slot ....... This complies with PC Card Standard Release 8.0.
(For future use)
FDD Connector
NOTE: The power switch does not function within 5 seconds after the POS
terminal is plugged in. Wait for more than 5 seconds, and then press
the power switch.
driver.
LINK/ACT: Yellow
SPEED: Green
USB V2.0/1.1 and UHCI (conforming to Universal Hub Controller Interface
V2.0/1.1)
NOTE: USB functions may not be supported depending on the Operating
System.
32-bit Card Bus card and 16-bit PC card are supported. One slot is
provided and accepts up to TYPE II card.
3- 1
LAN LED
LED type LED status
LINK/ACT ON/OFF
Blink
SPEED Off
On
PC Card Interface Slot
USB 3
3. CONNECTORS
Reset Switch
Brightness Control
LAN status
Linked/Unlinked
Frame is sent/received.
10M
100M
EO1-12028