Cardiac Science SURVIVALINK AED Operation & Service Manual page 36

300282-002 Rev. E0
3. Match the color code of the connectors (red to red), then slide the
electrode connector along the recess in the Survivalink AED case as
shown in the drawing, until the electrode connector fully mates to the
connector of the Survivalink AED.
4. Slide the electrode package fully into the Survivalink AED electrode
compartment, inserting the cable end first, as shown in the drawing.
5. Loop the excess cable length as shown in the drawing.
6. With the electrode package completely under the Survivalink AED
lid, as shown in the drawing, close the lid.
©2002 Cardiac Science, Inc.
Section 3: Setup
Page 33