Programming Motorola Trunking System (800 Mhz) - Radio Shack PRO-93 Owner's Manual

• If you try to program an offset frequency in the UHF-
Hi bands (806-960 MHz), the scanner ignores the
entry.
Follow these steps to program Motorola trunking fre-
quencies in the UHF-Lo band:
1. Press
PGM
mode.
2. Press
FUNC
the bank.
3. Press
MODE
4. Press
FUNC
on the first line,
=I<Hôèý =I<Hôèý
=I<Hôèý =I<Hôèý
E\\i[j0 0 0 0 ý).& E\\i[j E\\i[j E\\i[j ý).& ý).& ý).&
on the third line and
bottom line.
5. While in
â â â â
desired Base frequency with the number keys and
press
ENTER
press the number keys again to set the base fre-
quency. After you confirm the input, press
again.
Eý Eý Eý Eý E\\i[j E\\i[j
E\\i[j E\\i[j
6. While in
number and press
incorrect, then press the number keys again to set
the frequency. After you confirm the input, press
again.
ENTER
7. While in
/ / / / /K<G /K<G /K<G /K<G
select the step number,
press
ENTER
8. Press
PGM
trunking IDs into the sub-bank in the same bank.
Programming Motorola Trunking System
(800 MHz)
Notes:
• On the 800 MHz trunking band, you can select a
base frequency (normal or offset).
then to enter the ID program
TRUNK
and press (or hold)
and select .
)+0 )+0 )+0 )+0
then . The display indicates
2
î î î î òìô òìôòòòò òòòò
òìô òìô òòòò òòòò
blinks, if necessary, press the
â8J< â8J<
â8J< â8J<
. Confirm the entry. If it is incorrect,
blinks, if necessary, enter the offset
. Confirm the entry. If it is
ENTER
blinks, repeatedly press
,
ðíôò ðíôò
ðíôò ðíôò
.
to enter the program mode. Store the
Trunking Operation
8 8 8 8 9 9 9 9
or to select
â8J< â8J< â8J< â8J<
on the second line,
on the
/K<Gè è è è ýðíôòB$Q /K<G ýðíôòB$Q
/K<G /K<G ýðíôòB$Q ýðíôòB$Q
ENTER
8 8 8 8 9 9 9 9
or
or
íòôò íòôò ñðôíý B$Qõ ñðôíý B$Qõ
íòôò íòôò ñðôíý B$Qõ ñðôíý B$Qõ
to
then
55