Motorola MTH800 Feature User Manual page 92

• Interface allows you to enable/disable the GPS location
service.
• Setting Accuracy allows you to select high location
accuracy or the energy optimised mode for GPS location
service if the MTH800 is not connected to a charging
device (Digital Car Kit or charger etc.).
Scroll to your selection and press Select to access the next
display.
This estimate of accuracy of the calculated location is only a
very rough estimate and may vary substantially from the
actual accuracy of the approximate location information
reported.
This feature works in DMO and TMO modes when it is set by
the Service Provider.
The variation will vary in accordance to the GPS Configuration
set by your Service Provider.
The availability of the GPS Location menus is dependent on
your terminal configuration, please contact your Service
Provider for further details.
Viewing Your Position
1. From the main menu, press
select More....> Location > Position.
2. Scroll to view the entire screen.
This displays the following information about
the last time your location was calculated (if available):
• The time the location was last calculated
• The latitude expressed in degrees, minutes, and seconds
• The longitude expressed in degrees, minutes, and
seconds
• The number of satellites used to calculate the location. In
general, more satellites make for better accuracy. The
maximum is twelve satellites.
To calculate your location again, press Rfrsh.
84
Position
and
<Time>
<Latitude>
<Longitude>
<Tracked satellites>
Rfrsh Back