Fluke 990DSL User Manual page 162

990DSL
Users Guide
3. If the selection is correct, press the
primary
Ping Setups
4. During the Ping test, a selectable number of data packets is sent to the
target address, with a default of 4 packets. To send a different
number, highlight the
number (1 to 30).
5. Highlight the
to and select the desired connection type for the line under test:
•
PPPoE
•
PPPoE / Static IP
•
Static IP
•
DHCP
•
PPPoA
6. Press the
Using the
connection type (see Table 5-3 for descriptions of setup parameters).
7. After entering all of the required secondary
key to return to the
BACK
8. Press
TEST
Figure 5-12 shows the results of a Ping operation on a typical ADSL2+ line.
5-24
screen.
Packets
field. Then, using the
Connection
softkey to display the secondary
More
function, complete the required setups for the selected
Edit
Ping Status
to perform the network Ping operation.
softkey to return to the
Okay
field and edit it to display the desired
Edit
Ping Setups
Ping Setups
screen.
function, scroll
screen.
, press the