Advertisement
5.
Apply a drop of oil to the flyer spindle and slide a
bobbin on.
6.
Apply a drop of oil to the end of the flyer shaft and
feed it into the flexible motor drive. Note the flat on the
shaft aligns with the raised line on the flexible drive.
Snap the flyer down into the front flyer bearing. Apply
a drop of oil to lubricate this bearing. Don't over oil.
-1
-2
7.
Tie one end of the black waxed thread to the
end of the spring, thread through the screw eye
and tension knob and tie a knot.
8.
Place the nylon brake band
around the bobbin whorl, place
the tension knob in
the tapered hole and
tighten until the springs
just start to extend. This
is the normal amount
of brake band tension
required. Do not extend
the springs more than
1 ½ times their own
length.
9.
Locate the threading
hook into the tapered
hole in the front.
3
Advertisement
