Advertisement
Changing Batteries
(22)
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
Door/Window Contact Battery Change
(SE) Batteribyte - (DK) Batteriskift.
When the battery is low the LED will light up when the door/window is opened.
Note: Door/Window Contact case tamper conditions are also indicated by a lit LED, check the tamper before
changing the battery.
SR-KP
SR-KP
To change the battery:
(22)
1. Disarm
2. Unscrew
(GB) Changing batteries - (IT) Sostituzione batterie - (DE) Batteriewechsel - (NO) Batteribytte -
(SE) Batteribyte - (DK) Batteriskift.
SR-KP
SR-DC
SR-DC
Please ensure battery
is inserted correctly.
SR-DC
PIR Battery Change
SR-PC
SR-PC
When the battery is low the LED will flash when any motion is detected. The batteries are changed as
follows:
SR-PC
EF-PIR
SR-KP
1. Disarm 2.
SR-PIR / PETPIR
SR-PIR / PETPIR
Unscrew
SR-PIR / PETPIR
& remove
top case
SR-DC
SR-PC
1. Disarm
2.
SR-PC
Unscrew
& remove
top case
SR-PIR / PETPIR
28
•
CHANGE
BATTERY
SR-KP
3. Remove cap
SR-DC
top case.
SR-PC
2 x 1.5v AA
SR-PIR / PETPIR
3 x 1.5v AAA
Alkaline
3.
3. Insert
Remove
new
Batteries
Batteries
3. Remove old & insert
new Batteries
Please be careful
when removing case
as cable is very
delicate.
BATTERY
CHANGE
BATTERY
CR 2032
4. Remove battery
5. Insert new
2 x 1.5v AA
CR 2032
2 x 1.5v AA
2 x 1.5v AA
CHANGE
BATTERY
3 x 1.5v AAA
CR 2032
CR 2032
4. Refit.
2 x 1.5v AA
Alkaline
4. Refit.
3 x 1.5v AAA
CR 2032
CR 2032
CR 2032
CR 2032
CR 2032
CR 2032
6. Refit.
battery
3 x 1.5v AAA
3 x 1.5v AAA
Ensure tamper spring is fully
depressed when re-fitting the PIR to
the back case. If this has not been
done correctly this will be indicated by a
flashing LED on the PIR.
Hide quick links:
Advertisement
