MN002859A01-A
Chapter 10: Accessories
Desktop Cradle
A desktop cradle provides an alternative method to charge your LEX L10ig.
The desktop cradle:
•
Provides power for charging and operating the LEX L10ig
•
Enables connecting a mouse to the LEX L10ig
Figure 95: Desktop Cradle
Charging the LEX L10ig
To charge the LEX L10ig, insert the LEX L10ig units by placing the bottom of the LEX L10ig, at a slight
forward angle, into the cradle.
The LED of the LEX L10ig, shows the status of the battery charging. See Battery Charge LED Status
for charging status indications. The 2280 mAh battery charges in approximately four hours.
Charge the LEX L10ig units in temperatures from 0°C to +45°C (32°F to 113°F) ). Note that charging is
intelligently controlled by the LEX L10ig. To accomplish this, for small periods of time, the LEX L10ig
alternately enables and disables battery charging to keep the battery at acceptable temperatures. The
LEX L10ig indicates when charging is disabled due to abnormal temperatures via its notification LED.
Vehicle Cradle
Install the vehicle mount on the surface of the vehicle that is reasonably flat and free of dirt and oil.
Clean the mounting surface with a glass cleaner and a clean cotton cloth. Install the vehicle mount on
the windshield or other flat car surface.
CAUTION: Some states prohibit the mounting of any electronic device in any location on the
vehicle dashboard. Be sure to check with local laws acceptable mounting areas before installing
the auto mounting kit.
Figure 96: Vehicle Cradle
148
Send Feedback