Setting Ip Precedence And Dscp Values - Cisco NCS 5000 Series Manual

Setting IP Precedence and DSCP Values

Command or Action
Step 3
snmp-server queue-length length
Example:
RP/0/RP0/CPU0:router(config)# snmp-server
queue-length 20
Step 4
snmp-server trap-timeout seconds
Example:
RP/0/RP0/CPU0:router(config)# snmp-server
trap-timeout 20
Step 5 commit
Setting IP Precedence and DSCP Values
This task describes how to configure IP Precedence or IP DSCP for SNMP traffic.
Before You Begin
SNMP must be configured.
SUMMARY STEPS
1. configure
2. Use one of the following commands:
3. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
Use one of the following commands:
• snmp-server ipv4 precedence value
• snmp-server ipv4 dscp value
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
38
• snmp-server ipv4 precedence value
• snmp-server ipv4 dscp value
Purpose
(Optional)
Establishes the message queue length for each
notification.
(Optional)
Defines how often to resend notifications on the
retransmission queue.
Purpose
Configures an IP precedence or IP DSCP
value for SNMP traffic.
Implementing SNMP