Open An Existing Batch For Data Analysis; Creating A New Batch For Data Acquisition - Agilent Technologies Agilent 7700 Series ICP-MS Quick Start Manual

Open an existing batch for data analysis

If the window is not already open, open the ICP- MS Data Analysis window in
either of the following ways:
• Select Main Panel from the DataAnalysis menu in the ICP- MS Top window,
• Click the
Tip
To open an existing batch:

Creating a new batch for data acquisition

1 Create a new Batch Folder, which will be used to contain your data analysis
26
or
button on the ICP- MS Top toolbar.
a Select Open Analysis File from the File menu to open the Open Batch
dialog box.
b Select the file of interest and click Open. This opens an Analysis file with
data that has been previously acquired.
c Then proceed to
Quantitative data analysis"
(DA) method (if a DA method was not applied at time of data
acquisition) or to modify the method, if needed (if the DA method
was already applied).
results:
a Open the New Batch Folder dialog box in either of the following ways:
• Click the New Batch Folder toolbar button
• Select New Batch Folder from the File menu.
b Type in a name for the new folder (you may select a different location if
desired).
c Click the Create button.
G7200-90210 (Rev. A) MassHunter Workstation Quick Start Guide
"Create the Data Analysis (DA) method for
on page 28 to create a Data Analysis
, or