Setting Quantitative Method Parameters; Set Up A Quantitative Method - Agilent Technologies Agilent 7700 Series ICP-MS Quick Start Manual

Setting Quantitative Method Parameters

The following topics will help you create an acquisition method for
quantitative analysis with the Agilent 7700 Series ICP- MS MassHunter
Workstation.

Set up a Quantitative Method

Create a quantitative method for environmental analysis as described below:
1 Select Edit Entire Method from the Methods menu. This initiates a series
Tip
See also
2 On the Edit Method dialog box, mark the following options, then click OK.
3 On the Method Information dialog box:
12
of dialog boxes, so you can set the parameters for your method. See the
online help for a full description of the items on these dialog boxes.
"Use the Method Wizard to create a method"
a Enter a comment
b Mark the Data Analysis check box to run the data analysis automatically
after data acquisition. For instructions on setting up a Data Analysis
method, see "Open an existing batch for data analysis"
c Click OK.
G7200-90210 (Rev. A) MassHunter Workstation Quick Start Guide
on page 19.
on page 26.