MultiNet
GETTING STARTED WITH ENERVISTA TO SETUP MULTINET
The MultiNet setup software is provided to edit settings and configure the unit. The setup software
connects to the unit through either the 10BaseT (RJ45) port or the 10BaseF (fiber) port.
The following requirements must be met to ensure correct operation of the MultiNet setup software:
Pentium class or higher processor (Pentium II 300 MHz or higher recommended)
Windows 95, 98, 98SE, ME, NT 4.0 (Service Pack 4 or higher), 2000, XP
64 MB of RAM (256 MB recommended)
40 MB of available hard drive space (100 MB recommended)
Video capable of displaying 800 600 or higher in High Color mode (16-bit color)
An Ethernet communications port.
To download MulitNet directly, go to
To download MulitNet through enerVista (suggested), follow the procedure outlined below.
1. Download enerVista
a) From the Web:
i)
Direct your web browser to the enerVista website at http://www.enerVista.com. Click on
the "Downlaod Now" button.
ii) Run the enerVista installation program and follow the on-screen instructions.
b) From the enerVista CD:
i)
Insert the enerVista CD into your computer's CD drive and it will automatically open the
welcome page. Click on the "Install Now" button.
ii) Run the enerVista installation program and follow the on-screen instructions.
GE Digital Energy
Courtesy of NationalSwitchgear.com
http://www.geindustrial.com/multilin/software/multilin.htm
Page 5 of 15
http://www.GEmultilin.com