Dubbing To A Video Unit Equipped With A Dv Connector (Digital Dubbing) - JVC GR-D820EK Instructions Manual

44
EN Connections/Editing Connections/Editing
Dubbing To A Video Unit
Equipped With A DV
Connector (Digital Dubbing)
It is also possible to copy recorded scenes from
the camcorder onto another video unit
equipped with a DV connector. Since a digital
signal is sent, there is little, if any, image or
sound deterioration.
Core Filter
Video unit equipped with DV connector
1 1
1 1
Make sure all units are turned off.
2 2
Connect this camcorder to a video unit
2 2
equipped with a DV input connector
using a DV cable as shown in the
illustration.
3 3
Start playback on the camcorder
3 3
( 23).
4 4
4 4 At the point you want to start dubbing,
start recording on the video unit. (Refer
to the video unit's instruction manual.)
5 5
5 5 To stop dubbing, stop recording on the
video unit, then stop playback on this
camcorder.
To DV OUT
DV Cable (optional)
To DV IN
Notes:
● It is recommended to use the AC Adapter as
the power supply instead of the battery pack
( 18).
● If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not
dubbed.
● Even though the DV cable is connected
correctly, sometimes the image may not appear
in step . If this occurs, turn off the power and
4 4
4 4
make connections again.
● If "Playback Zoom" (
Effects" ( 25) is attempted or SNAPSHOT is
pressed during playback, only the original
playback image recorded on the tape is output
from the DV OUT connector.
● When using a DV cable, be sure to use the
optional JVC VC-VDV204U or VC-VDV206U DV
cable.
25) or "Playback Special