JVC GR-D820EK Instructions Manual page 49

Warning Indication
High
Exhausted
SET TO MANUAL MODE
TAPE END
LENS CAP
SET DATE/TIME!
CHECK TAPE'S ERASE
PROTECTION TAB
A. DUB ERROR!
GR-D860
<CANNOT DUB ON A LP
RECORDED TAPE>
<CANNOT DUB ON A
16BIT RECORDING>
<CHECK TAPE'S ERASE
PROTECTION TAB>
INSERT ERROR!
GR-D860
<CANNOT EDIT ON A LP
RECORDED TAPE>
<CHECK TAPE'S ERASE
PROTECTION TAB>
<CANNOT EDIT ON A
BLANK PORTION>
MEMORY IS FULL
GR-D860
UNIT IN SAFEGUARD
MODE
REMOVE AND
REATTACH BATTERY
OR DC PLUG
UNIT IN SAFEGUARD
MODE
EJECT AND REINSERT
TAPE
* The camcorder turns off automatically. Re-check if the indication clears. When it does, you can resume
using the camcorder. If the indication remains, consult your nearest JVC dealer.
● Displays the battery remaining power.
● As the battery power comes close to nil, the battery remaining power
indicator blinks. When the battery power is exhausted, power turns
off automatically.
● Appears when you attempt to change "Menu Settings", "Backlight
Compensation" or "Manual Focus" while in AUTO mode A (
● Appears when the tape ends during recording or playback.
● Appears for 5 seconds after power is turned on if the lens cap is
attached or when it is dark.
● Appears when the date/time is not set (
● The built-in clock battery has run out and the previously set date/time
has been erased. Consult your nearest JVC dealer for replacement.
● Appears if a tape is loaded while the Power Switch is set to
.
"REC"
● Blinks when no tape is loaded.
● Appears when the erase protection tab is set to "SAVE" while the
Power Switch is set to "REC".
● Appears if Audio Dubbing is attempted on a blank portion of a tape
( 46).
● Appears if Audio Dubbing is attempted on a tape recorded in the LP
mode ( 46).
● Appears if Audio Dubbing is attempted on a tape recorded in 16-BIT
audio ( 46).
● Appears if A. DUB (
erase protection tab is set to "SAVE" (
● Appears if Insert Editing is attempted on a tape recorded in the LP
mode ( 46).
● Appears if INSERT (I) on the remote control is pressed when the
erase protection tab is set to "SAVE". (
● Appears if Insert Editing is attempted on a blank portion of a tape
( 46).
● Appears when the memory card's memory is full and shooting is not
possible.
● Error indications (01, 02 or 06).
Remedy: Remove and reattach the power supply or battery*.
● Error indications 03 or 04.
Remedy: Eject the cassette and re-insert*.
Troubleshooting
Meaning / Remedy
19).
D
) on the remote control is pressed when the
46).
46)
49
EN
22).