Table of Contents
Advertisement
Dubbing To Or From A Video Unit
Equipped With A DV Connector (Digital
Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if
any image or sound deterioration.
Core filter
Video unit equipped with DV connector
To DV IN/OUT
DV cable
(optional)
To DV IN/OUT
To use this camcorder as a player
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit equipped with
a DV input connector using a DV cable as shown in the
illustration.
3
Start playback on the camcorder. (
4
At the point you want to start dubbing, start recording
on the video unit. (Refer to the video unit's instruction
manual.)
5
To stop dubbing, stop recording on the video unit, then
stop playback on this camcorder.
NOTES:
● It is recommended to use the AC Adapter as the power
supply instead of the battery pack. (
● If a blank portion or disturbed image is played back on the
player during dubbing, the dubbing may stop so that an
unusual image is not dubbed.
● Even though the DV cable is connected correctly,
sometimes the image may not appear in step 4. If this
occurs, turn off the power and make connections again.
● If "Playback Zoom" (
pg. 22) or "Playback Special Effects"
(
pg. 22) is attempted or SNAPSHOT is pressed during
playback, only the original playback image recorded on the
tape is output from the DV IN/OUT connector.
● When using a DV cable, be sure to use the optional
JVC VC-VDV204U DV cable.
To use this camcorder as a recorder
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit equipped with
a DV output connector using a DV cable as shown in the
illustration.
3
Set "REC MODE" to "SP" or "LP". (
4
Set the camcorder's Power Switch to "PLAY".
5
Press the Recording Start/Stop Button to engage the
Record-Pause mode.
● The "
" indication appears on the screen.
DV. IN
6
Start playback on the player.
7
At the point you want to start dubbing, press the
Recording Start/Stop Button to start dubbing. The
indication rotates.
8
Press the Recording Start/Stop Button again to stop
dubbing. The
indication stops rotating.
9
Press 8 to return to the normal playback mode.
NOTES:
● If no image is displayed on the LCD monitor, set "S/AV
INPUT" to "OFF". (
pg. 29, 32)
● Digital Dubbing is performed in the sound mode recorded
on the original tape, regardless of the current "SOUND
MODE" setting. (
pg. 30)
EDITING
41
EN
pg. 19)
pg. 13)
pg. 29)
Advertisement
Table of Contents
