Table of Contents
Advertisement
10
THROTTLE LINKAGE AND IGNITION LEADS
1.
Unscrew air filter cover knob and remove cover.
2.
Place inner throttle cable in slot of carburetor swivel (B).
3.
Loosen nut (A) and place threaded end of throttle linkage into
mounting bracket. Finger tighten nut (A).
4.
Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly. Tighten nut (A).
If adjustment cannot be achieved by adjusting nuts, consult with
your Echo Dealer for correct adjustment procedure.
5.
Connect 2 ignition leads from throttle cable (C, D) tubing to 2
ignition leads (C, D) on engine. Gather iginition wires, and position
behind air filter case.
6.
Install air filter and cover.
FRONT HANDLE
Tools Required: Cross-Head Screwdriver
Parts Required: Front Handle, Lower Bracket, 4 - 5x35 mm screws
NOTE
Label shows minimum spacing for front handle location.
1.
Assemble front handle and bracket loosely to drive shaft.
2.
Position front handle in comfortable operating position and tighten
screws.
A
B
C
D
MIN
SPACING
Advertisement
Table of Contents
