Table of Contents
Advertisement
GENERAL INFORMATION
1.1. Introduction and Description
This user manual explains the installation, operation and maintance of the RTRC10 rotor controller. The
RTRC10 is a stand alone rotor controller which can measure azimuth position using pot for voltage / current
measurements or pulse sensor, which is built in your tower rotor, ring rotor or other antenna rotator.
1.2. Owner Assistance
If assistance is needed, you should contact your local dealer first. If you still have problems during
installation/use you can use e-mail _______________________ , or by telephone _____________________.
1.3. Equipment & Accessories Supplied
The RTRC10 rotor controller is shipped with this manual, 220 VAC cable, USB cable for programming
and software upgrades. LAN Cable for Slave / User Interface mode is supplied at request.
1.4. Features
Easy to operate
•
Pot for voltage / current measurements or pulse sensor
•
Point & shoot operation
•
Manual operation up to one degree
•
Over North / Over South rotation
•
Networked controllers, up to 3 User Interfaces can be attached to single controller for Multi Op
•
environment
Master or Slave configuration for tracking separate rotor on the tower
•
PC Controlled
•
4 programmable memories
•
More the 360 degrees rotation
•
Extra relay can be supplied, at your request, for rotors with break built in
•
Extra transformer can be supplied, at your request, for controlling your favorite rotor
•
1.5. Warranty
This product is warranted to be free of defects in materials and workmanship for 1 year. We will repair or
replace, at our option, any equipment proven to be defective within the warranty period. This warranty is
exclusive of abuse, misuse, accidental damage, acts of God or consequential damages, etc.
__________________. liability shall not exceed the original purchase price of the equipment. Save your
warranty card as a proof of 1 year warranty.
1.
Advertisement
Table of Contents
