Table of Contents
Advertisement
MENU ITEMS – SETUP 3/4
There can be 4 rotor controllers connected to work in network. Only one rotor controller can be set as
Master (that controller is connected to Rotor). In the network there can be 3 more controllers as User
Interfaces. User Interfaces can pass commands to Master and work as Master in this virtual network. There is
only one exception. PC can not be connected to Master via USer Interface.
In
SETUP MENU 3/4
choose what type is your Rotor Controller
REMINDER:
IF YOU HAVE ONLY ONE CONTROLLER IT MUST BE MASTER!
Track master and No Track Master is not implemented yet!.
MENU ITEMS – SETUP 4/4
In case of big antenna sistems on one tower, because inertion, there is a case that tower will not stop in the
moment when controller stop rotation. In that case we can set up controller to stop rotation few degrees
before requested position.
If this option is interesting for you, choose
HwMuchAdv:
position and with CW or CCW setup value of degrees when the motor will stop.
To EXIT SETUP press ESC
SETUP 3/4
Master
User Intfc1
User Intfc2
User Intfc3
Track Mast √
NoTrackMast
ONLY ONE CONTROLLER CAN BE MASTER!
SETUP 4/4
NoStopInAdv
Stop In Adv
HwMuchAdv:
Picture 10.
STOP IN ADV
√
Picture 9.
MASTER
/
√
010
and memorise it. With REQUEST walk to
USER INTERFACE
1, 2 or 3.
Advertisement
Table of Contents
