Table of Contents
Advertisement
NETWORK MODE
10.
WORKING IN NETWORK MASTER / USER INTERFACE
Your Rotor Controller is capable to work in network. There is 4 Controllers which can be used in one
network.
If we want to use this future we should use RJ 45 Network cable to connect MASTER with USER
INTERFACES. They are coneceted in RAW MA > UI1 > UI2 > UI3.
Previoslu we should setu up contollers as MASTER, USER INTERFACE 1 ... USER INTERFACE 3.
NETOWORK CABLE MUST BE PIN TO PIN not CROSS OVER one.
DATA TRANSFER
Before we beggin we shold transfer complete setup from MASTER to USER INTERFACE.
That can be done on the following way :
RESET MASTER (press ESC and ENTER). On the display we will get message RESET. Release ENTER
and hold ESC. On display we will get message KEY OK TO SEND TO UI.
Do the same on USER INTERFACES. We will get message WAIT FOR DATA FROM MA.
Then we sholud pres ENTER on MASTER and all date will be transfered to USER INTERFACES.
With USER INTERFACE we can controll MASTER controller. We can use REQUEST, CW or CCW and ESC
to stop rotation.
When controller is USER INTERFACE PC communication is not possible!
Advertisement
Table of Contents
