Table of Contents
Advertisement
PC MODE
Your rotor controller is HY-Gain DCU-1 type with 4800 bps speed!
RTRC 10 FIRMWARE
To check FIRMWARE version press RESET [ESC+ENTER] and then hold [CCW], last version is 3.xx.
To update controller with new version you must have Tinybootloader and USB2COM CDM 2.04.06 driver .
HOW TO:
1. First install CDM 2.04.06
2. Connect RTRC 10 with USB cable to your PC (POWER ON)
3. PC must see RTRC 10 as USB DEVICE and to assign com port for RTRC 10
If PC see RTRC10 proceed ... If not try with different USB port or with other cable
4. On your PC make folder for Tiny bootloader (there is no installation). In RAR archive there is file
RotorCtrV2xx.hex (new sw update).
5. Start Tinybootloader
6. On the left side choose com port where is RTRC 10, com port is assigned by PC.
Choose 57600 bps speed for this com port
7. Press browse button on the top of user screen of Tiny bootloader.
Choose RotorCtrV2xx.hex file in Tinybootloader folder
8. RESET RTRC 10 [ESC+ENTER] and press WRITE FLASH in Tinybootloader sw.
9. Wait until screen on RTRC 10 come to normal.
10. Restart your RTRC 10 controller.
11. Check for version of SW RESET + CCW.
Picture 1.
11.
Advertisement
Table of Contents
