Table of Contents
Advertisement
If ver is 3.xx proceed ...
This procedure is for any software update for RAC-X Rotor Controller!
PLEASE NOTE THAT YOUR CONTROLLER AND ANY SW COMMUNICATE AT SPEED OF 4800bps!
SPEED OF 57600bps is only needed when you are updating your Controller internal software!
N8LP LP-ROTOR
If you want to use LP-ROTOR for controlling your RAC-X Controller you must first download it from N8LP site.
http://www.telepostinc.com/LP-Rotor-Html/. N8LP is owner of LP-ROTOR software!
HOW TO:
1. First install CDM 2.04.06
2. Connect RTRC 10 with USB cable to your PC (POWER ON)
3. PC must see RTRC 10 as USB DEVICE and to assign com port for RTRC 10 (Picture 1.)
4. Start LP-ROTOR (Picture 2.)
5. To setup LP-ROTOR open Setup tab (Picture 3.)
6. To setup your controller to turn over North you must add offset value of -180, all other values in SETUP
dialog are well described by N8LP on
7. To setup your controller to turn your rotor over South add offset value 0.
8. Now your controller is ready to be use with N8LP LP-Rotor
Picture 2.
Picture 3.
http://www.telepostinc.com/LP-Rotor-Html/
Advertisement
Table of Contents
