Updating The Firmware - Datalogic Joya User Manual

Use and Functioning

Updating the Firmware

After copying the firmware image to the host PC and installing DFU,
you can upgrade the firmware on your Datalogic device.
The following steps require that you have already
established an ActiveSync or Windows Mobile® Device
Center connection between the host computer and the
Datalogic device.
NOTE
1. Go to Start > Programs > Datalogic > DFU > Datalogic Firmware
Utility.
2. Verify that ActiveSync is selected by clicking Communications >
WMDC/ActiveSync.
3. Click browse (...) and navigate to the location where you saved
the firmware file for your terminal.
4. Select the current *.out file and click Open.
5. Click Update.
6. DFU will compare the selected firmware image with the firmware
already loaded on the device; if the image is compatible with the
connected device, DFU will proceed to update the firmware image
on your device.
After the firmware of your device has been updated, the program will
automatically perform a warm reset of the device.
68 JOYA™ TOUCH