Table of Contents
Advertisement
2. Function Overview
2.2
System Interface
The evaluation board includes a large number of connectors that support different interfaces to allow
compatibility with a wide range of setups evaluated by clients. Table 2-1 lists these interfaces.
Section 3 lists details of the interfaces.
Interface
PC USB interface
SPI master
SPI slave
Speaker out
2.3
Board Connection
The evaluation board can be connected in three different ways, as shown in the figures below.
(1) Fig. 2-2: Allows audio data generated using the audio generation tool to be played back and
checked on the audio IC.
(2) Fig. 2-3: Allows development and debugging using the client's host CPU.
(3) Fig. 2-4: Allows operation checking and debugging of the audio IC board developed by the
client.
(3) Fig. 2-5: ROM with a built-in audio IC can be emulated by connecting the optional ROM
emulator.
For details, refer to the S1V3033X ROM Emulator Hardware User Guide.
For evaluations based on the configurations shown in Figures 3 and 4, fit a connector to suit the
client's board to the "open" end of the cable provided. Clients using the board while connected to an
external host (Fig. 2-3) or an evaluation board host (Fig. 2-4) should contact Seiko Epson for detailed
specifics.
4
Table 2-1 Interface/connector list
Connector
J5
J10
J11
J14,J15,J16
Fig. 2-2 PC host connection diagram
EPSON
Function
Power/data control line
SPI master interface
SPI slave interface
Speaker out jack
S1V30333/300/120 Evaluation Board
User Guide (Rev. 1.03)
Advertisement
Table of Contents
