Table of Contents
Advertisement
Chapter I. Chelsio Unified Wire
viii. Finally, add the image file to WDS server and install Nano Server (with Chelsio drivers)
using PXE boot.
ix. The Nano Server machine will reboot.
In case of non-WHQLed drivers, run the following command to enable test signing and
Note
reboot the machine again:
[nanomachine-ip]: PS D:\> bcdedit /set testsigning on
Chelsio T5 Unified Wire for Windows
25
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Chelsio Communications Terminator 5
Related Products for Chelsio Communications Terminator 5
- Chelsio Communications Terminator Series
- Chelsio Communications Terminator T5 Series
- Chelsio Communications Terminator T4 Series
- Chelsio Communications Terminator N320E-CXA
- Chelsio Communications Terminator 6
- Chelsio Communications Terminator T3 Series
- Chelsio Communications Terminator T6 Series
- Chelsio Communications Terminator T6225-CR
- Chelsio Communications Terminator T6225-LL-CR
- Chelsio Communications Terminator T6225-SO-CR
- Chelsio Communications Terminator T62100-CR
- Chelsio Communications Terminator T62100-SO-CR
- Chelsio Communications Terminator T62100-LP-CR
- Chelsio Communications Terminator T580-SO-CR
- Chelsio Communications Terminator T520-SO-CR
- Chelsio Communications Terminator T520-BT
Need help?
Do you have a question about the Terminator 5 and is the answer not in the manual?
Questions and answers