Zip Package - Chelsio Communications Terminator 5 Installation And User Manual

Chapter I. Chelsio Unified Wire
3.4.

Zip Package

Chelsio Unified Wire zip package provides two methods of installation: Manual and using Offline
Windows Image. In Manual method, the driver components will have to be individually installed
using the Device Manager. Using the second method, you can add Chelsio driver components to
an offline OS image. The image can then be used to install Windows on your system.
Enabling Test Signing
In case the drivers in the package are not WHQL certified, please follow the steps mentioned
below to enable test signing before installing Unified Wire:
1. Open command prompt and run the following command to enable test signing:
C:\Users\Administrator>bcdedit /set testsigning on
2. Change your working directory to ChelsioUwire-x.x.x.xx/Selfsign/ and run the following
commands:
C:\ChelsioUwire-x.x.x.xx\Selfsign> .\certmgr.exe -add chelsiocert.cer -s -r
localmachine root
C:\ChelsioUwire-x.x.x.xx\Selfsign> .\certmgr.exe -add chelsiocert.cer -s -r
localmachine trustedpublisher
3. Reboot the machine for the changes to take effect.
Manual

The driver components need to be installed strictly in the order described
Important
here. Using any other order is not supported.

Before proceeding, open Device Manager and disable NDIS Miniport driver
(Network adapters->Chelsio Network Adapter) followed by Virtual Bus Driver
(System devices->Chelsio T5 40G/10G Bus Enumerator).
Virtual Bus Driver
i. Open Device Manager (Control Panel -> System & Security-> System -> Device Manager),
click on System Devices, right click on Chelsio T5 40G/10G Enumerator and select
Update Driver Software.
ii. Select Browse my computer for driver software.
iii. Select Let me pick from a list of device drivers on my computer and click Next.
iv. Click on Have Disk Button and on the next screen browse for chvbdx64.inf file and click
Open and then OK.
Chelsio T5 Unified Wire for Windows 22