Determining And Maximizing Range; Mounting - Omega UWTC-1 User Manual

6
System Operation

6.7 Determining and Maximizing Range

The available maximum range specified for the wireless Series system in this
manual is only achievable under optimum installation conditions. Mounting
height, obstructions in your "Fresnel Zone" and ambient conditions can cause a
decrease in signal strength resulting in a shorter range between your transmitter/
connector and receiver unit.
The following recommendations will help to improve the range of your
wireless system.
Position your receiver in a central location
When multiple connector/transmitters are in operation, position your
receiver unit in a central space if possible in equal distance to each connector
transmitter.
UWTC-2
CHAN 6
MANUFACTURING
UWTC-2
CHAN 5
Test your system before permanent mounting
Before permanently mounting your connector/transmitters in your application
try moving the devices to different locations and mounting angles to
determine what installation achieves the best signal strength.
Move your system components higher off the floor and away from exterior walls
Avoid installing your system components to close to the floor or near your
buildings exterior walls. The closer your connector/transmitter and receiver
unit are the greater the interference and lose of signal strength will be.
Maintain a line of sight (LOS) between antennas
Maintaining a line of sight between your connector/transmitter and receiver
unit will produce greatly improved signal strength over a system were the
antenna's in your system have obstacles blocking them.
Maintain a constant ambient temperature environment
Maintaining a constant ambient temperature environment is important to
achieving maximum signal strength. Exposing your system components to
extreme hold or cold temperatures, or sudden changes in ambient conditions
will have an effect on the performance of your system.
6-5
Figure 6-5. Determining Maximum Range
UWTC-1
CHAN 3
AREA
UWTC-1
CHAN 4
NOTE:
CONTROL ROOM
PC
RECEIVER
STORAGE ROOM
UWTC-2
CHAN 1
MANUFACTURING
AREA
UWTC-2
CHAN 2
OFFICE OFFICE