Channel Display Box Screen - Omega UWTC-1 User Manual

②
Address Field
Here you must set an address number into this box that corresponds to a
matching Connector/Transmitter unit that you are using in your system. For
the system to work correctly each Connector/Transmitter must have a number
programmed that is different then other units in your system. Click with your
mouse on the "Up" and "Down" buttons to advance to a higher or lower
address number.
③
Low Alarm/High Alarm
When the "High" or "Low" Alarm box is checked the alarm feature becomes
active. Click with your mouse on the "Up" and "Down" buttons to advance
to a higher or lower setting. The displayed temperature reading will change
to RED digits and begin blinking to indicate that the process temperature has
gone below the low alarm or exceeded the high alarm value.
④
Hide
When the "Hide" box is checked the particular box that you are configuring
will become inactive and will not show up on the screen when running the
TC-Central program. This is used to remove unused boxed when less than 12
Connector/Transmitter units are being used.
⑤
Display Timeout
The Display Timeout setting is used to set how long you want the unit to
continue showing the last reading data when communication between the
Connector/Transmitter and receiver has been lost. Make sure not to set
this value to a time less than the current sample rate programmed into the
Connector/Transmitter or you will never receive and or display any readings.
⑥
Process Units
This drop down allows selection of the engineering units displayed for the
process input. A similar drop down is available for the ambient units.
⑦
Offset
Offset Calibration
➇
Device Dependent Settings
These buttons allow the user to perform additional configuration for specific
end device types.
1
5
6
Figure 3-12. Channel Display Box Screen
3
Software
2
3
4
7
8
9
3-8