Receiver Operation - Omega UWTC-1 User Manual

6
System Operation

6.5 Receiver Operation

6.5.1 Indicator Lights
(1) Transmit (TX) Green Indicator Light
The top green indicator light marked "TX" on the front of the receiver will
only blink when the receiver is connected to your PC and you initialize your
measurement software. After the receiver establishes communication with the
program the light will no longer blink. Note: this may happen very fast and
will not be noticeable.
(2) Receive (RX) Red Indicator Light
The red indicator light marked "RX" on the front of the receiver will blink
each time the receiver receives incoming data from one of your connector
transmitters.
(3) Standby (SB) Yellow Indicator Light
The yellow indicator light marked "SB" on the front of the receiver will blink
continuously during normal operation. This indicates that the receiver is in
the "Standby" mode and is waiting for incoming data from your connector/
transmitter.
(4) Power (PWR) Green Indicator Light
6-3
PRESS
SETUP
1
TX
PRESS
ON/OFF
LOW BATT
2
UWTC
UNIVERSAL WIRELESS THERMOCOUPLE CONNECTOR
Figure 6-3. Transmit and Low Battery Lights
1
RX
2
PWR
3
4
Figure 6-4. Indicator Lights
®
TX
SB