Table of Contents
Advertisement
Flashing Power LED but no connection?
There's no need to worry if the Power LED blinks red and you can no
longer connect to the WAN. This simply indicates that a preset time or
connect-charge limit has been reached. There are three methods
available for unlocking:
Reset connect charge protection.
Increase the limit that has been reached.
Completely deactivate the lock that has been triggered (set limit
to '0').
If a time or connect charge limit has been reached, you will be notified in LANmonitor. To
reset the connect charge protection, select Reset Charge and Time Limits in the context
menu (right mouse click). You can configure the connect charge settings in LANconfig under
Management
Costs (you will only be able to access this configuration if 'Complete con-
figuration display' is selected under View
You will find the connect charge protection reset in WEBconfig and all parameters under
Expert Configuration
·
Online
The Online LED indicates the overall status of all WAN ports:
off
green
green
green
red
»
ADSL
Connection status of the ADSL link:
off
green
green
green
green
green
tion about a later assignment of the configuration password see the
section 'Security settings'
Options...).
Setup
Charges- module.
no active connection
flashing
Establishing first connection
inverse flashing
Establishing further connection
constantly on
At least one connection established
constantly on
Error establishing the previous connection
interface switched off
blinking
Initialisation
flashing
Establishing first connection
invers flashing
Establishing further connection
constantly on
at least one connection established
flickering
Data traffic (send or receive)
LANCOM 1722 VoIP – LANCOM 1724 VoIP
Chapter 2: Installation
→
page 120.
Signal for reached time
LANCOM
Systems
or connect-charge
limit
43
Advertisement
Table of Contents
