Assembly And Adjustments - Porter-Cable PCXB620DP Instruction Manual

ASSEMBLY AND ADJUSTMENTS

Estimated Assembly Time: 25 - 35 Minutes.
WARNING
!
●
For your safety, never connect plug
to power source receptacle until all
assembly and adjustment steps are
all complete, and you have read and
understood the safety instructions.
●
The drill press is a heavy power tool
and should be lifted with the help
of two people OR MORE to safely
assemble it.
ASSEMBLING COLUMN TO BASE (FIG. A)
1. Position the base (2) on a flat and stable
work surface (must be able to support
100 lbs.).
2. Place the column assembly (1) on the
base (2). Align the three mounting holes
of the column assembly to the holes of
the base.
3. Bag "G" - Locate the three hex bolts (3)
from the parts bag.
4. Place a hex bolt (3) in each hole through
the column assembly and thread into the
base. Tighten with a 12 mm wrench.
Fig. A
3
INSTALLING THE TABLE (FIG. B~F)
1. Bag "G" - Install the table lock handle (1)
into the hole at the rear of the table
bracket (4).
NOTE: Install the handle from left to right,
so it enters the non-threaded side of the
table bracket first.
2. Bag "G" - Insert the worm gear (2) into the
table crank handle hole (3) from inside of
the table bracket (4). Make sure the worm
gear (2) meshes with the inside gear.
NOTE: Do not remove the lubrication
from this worm gear.
1
2
Fig. B
4
3
3. Place the rack (5) into the inside of table
bracket (4) as shown in Fig. C, making
sure the worm gear (2) in the table
bracket (4) is engaged with the teeth of
the rack (5) and the arrow stamped on the
rack is pointing up.
4. Slide the table with the rack onto the
column. (Fig. D)
5. Engage the bottom of the rack (5) with
the lip of the column assembly. Tighten
the table lock handle (1) to lock the table
to the column assembly.
NOTE: Do not overtighten.
Fig. C
4
5
Fig. D
1
14
2
1
2
5