Pneumatic Controls; Electrical Connections - GE Druck DPI 610 User Manual

Pneumatic Controls (Figure C2)
An AN4 connector provides the output connection.
The instrument is designed to operate with 5 metres of 6mm bore pipe attached.
Note:

Electrical Connections

Refer to publication K0415 pages 6 and 7 for the fitting of batteries and the charging of
batteries.
Maximum Instrument Ratings
The following table shows the maximum measurement ratings of the standard
instrument that should not be exceeded. Pressure over range (120% of FS) is indicated
by a flashing pressure display. Voltage or current over range (110% of max) causes
either the voltage or current display to flash.
When the AERO task is selected, the display flashes if the voltage or current input over
Note:
ranges by 110% of the above maximum values. The pressure display flashes at altitudes
below -3000 ft and above 50,000 ft or at airspeeds greater than 600 knots, depending on
the mode selected.
K0237 Issue No. 2
CLOSE
OPEN
Figure C2 - Pneumatic Controls
2