GB
07.6 ADJUSTMENTS AND SETTINGS
All controls for the adjustments and settings neces-
sary when using the generator are mounted on the
control panel and are described in this Chapter.
It is forbidden to perform further adjustments and
settings other than those described here.
Any adjustment and setting other than
those made by the manufacturer may
compromise the reliability of the power
generator and make the warranty void.
The engine oil level should be checked
daily by the operator, using the dipstick
located on the left side of the unit.
Do not disconnect the battery cables
when the generator is running as this can
cause improper operation of the battery
charger.
Stop the engine before fuelling. Do not
smoke when fuelling. Do not perform
fuelling near flames.
Do not overfill the fuel tank and clean up
any spillages. Check daily that there is no
leakage of fuel or oil from the engine.
When using the generator on its trolley, it
is the operator's responsibility to position
the unit in a safe location.
07.7 PUTTING THE GENERATOR
TEMPORARILY OUT OF SERVICE AND
RESTARTING OPERATION
If the generator is put out of service for longer than
6 months, it is advisable to disconnect the negative
terminal of the battery and to leave engine oil and fuel in
to protect mechanical parts, along with the fuel supply,
injection system and the fuel tank from oxidation.
When putting the generator back to service, all fluids
should be replaced, the battery should be charged,
engine belts, if any, all couplings and fuel pipes and seals
should be checked.
In case of longer out of service periods, contact
manufacturer Service Department.
34
498-1060
07. USING THE GENERATOR
SKD100
Need help?
Do you have a question about the SKD100-I and is the answer not in the manual?
Questions and answers