Pioneer DVR-LX61D Service Manual page 52

1
[4] OSD Filter Setting (Subscreen 4)
A
Depending on the monitor used, the character flicker on the OSD may stand out.
[Purpose]
If a system, such as character flicker, appears on the monitor, select the filter response.
[Tools to be used]
B
Remote control unit for servicing
[How to enter]
• While the User Operation screen is displayed, press the
key four times, in that order.
• While subscreen 3 of the first screen is displayed, press the
[How to quit]
Press the
C
[Setting procedures]
Display subscreen 4.
Select the setting from the key operation table.
[Tips]
As the setting value becomes greater, jitter is reduced on a CRT display. However, as lines for characters appear thick,
D
complex characters may become difficult to read. On the contrary, as the setting value becomes smaller, jitter
increases on a CRT display. However, as lines for characters become sharper, complex characters become more
legible.
Note: Use the remote control unit for servicing.
Note: A new setting becomes active as soon as it is made. As a new setting is stored in nonvolatile memory, it will be
retrieved when the unit it turned on the next time.
Note: After the factory-preset values are downloaded, the setting value for the OSD Filter will be the default value (4).
[(Table 2) Key operation of OSD Filter setting]
E
Key
[ Rev x 3 ], [SPEED+]
Changing the setting value for the
OSD Filter
[ x 3 Fwd], [SPEED-]
[CLEAR] The setting value is reset to default.
To exit the OSD Filter Setting and
[ESC] clear the screen (Appears the tuner
screen.)
F
52
1
2
(GGF1381)
key.
ESC
Operation
2
3
ESC
DIG/ANA
OSD Filter Setting
OSD FILTER :
Subscreen 4
Setting value
0 - 4 (Default value: 4)
–
–
DVR-LX61D
3
4
then keys, then the
DISP
key.
4
Remarks
[ Rev x 3 ], [SPEED+]
: The setting value increases by 1.
[ x 3 Fwd ], [SPEED-]
: The setting value decreases by 1.
–
4
DIG/ANA