Mounting The Base Ona Wall Plate - Radio Shack ET-1110 Owner's Manual

43-1110.fm Page 9 Wednesday, August 18, 1999 8:22 AM
8. Fully extend the base's antenna and
raise it to a vertical position.
MOUNTING THE BASE ON
A WALL PLATE
1. Remove the bracket by holding in
both tabs and gently pulling out the
wide end of the bracket.
2. Plug one end of the supplied short
modular cord into the phone jack on
the back of the base.
3. Insert the supplied AC adapter's
barrel plug into the
the back of the base.
4. Route the modular cord through the
left groove on the bottom of the
base and the adapter cord through
the groove below the strain relief
slot.
jack on
DC 9V
9