Mounting The Base On A Wall Plate - Radio Shack ET-598 Owner's Manual

43-698a.fm Page 8 Friday, August 13, 1999 12:56 PM
5. Plug the other end(s) of the modu-
lar cord(s) into
jack(s).
6. Raise the base's antenna to a ver-
tical position and fully extend it.
8
Mounting the Base
the modular
on a Wall Plate
To make this connection, you need a
2-line short modular cord, such as
Cat. No. 279-390 (not supplied).
1. If you have a single 2-line modular
jack on the wall plate, plug one
end of a 2-line short modular cord
into the jack.
TEL LINE 1/2
Note: When you make this con-
nection, you should not connect
another modular cord to the
jack or phone operation will
LINE 2
be erratic.
If you have a single 1-line modular
jack on the wall plate and a modu-
lar wall jack close by, plug one
end of a short modular cord into
the jack to use line 1,
TEL LINE 1/2
then connect the supplied modu-
lar cord into the
TEL LINE 2
use line 2.
If you have only a single 1-line
modular jack on the wall plate,
plug one end of a short modular
cord into the
TEL LINE 1/2
use line 1, or to the
jack to use line 2.
TEL
jack to
jack to
TEL LINE 2