Mounting The Base On A Wall Plate - Radio Shack ET-926 Owner's Manual

43-1096.fm Page 6 Tuesday, August 17, 1999 3:47 PM
3. Insert the supplied AC adapter's
barrel plug into the
on the back of the base.
4. Route the adapter's cord through
the strain relief slot on the base.
Strain Relief
Slot
5. Plug the adapter into a standard
AC outlet.
6. Lift the base's antenna to a verti-
cal position.
6
Mounting the Base on a
jack
DC IN 9V
Wall Plate
1. Insert the two catches at the top of
2. Plug one end of the supplied short
the bracket into the upper slots on
the bottom of the base. Then
press the two latches on the sides
of the bracket into the lower slots.
modular cord into the
jack on the back of the base.
TEL LINE