Placing The Base On A Desk Top; Mounting The Base On A Wall Plate - Radio Shack RT-551 Owner's Manual

43-1051.fm Page 6 Tuesday, August 17, 1999 1:08 PM
Placing the Base
on a Desk Top
Follow these steps when you place
the base on a desk, shelf, or table.
1. Plug one end of the supplied long
modular cord into the
the back of the base.
2. Insert the supplied
adapter's barrel plug into the
jack on the back of the base.
12V
3. Route the adapter's cord through
the strain relief slot on top of the
base.
Strain Relief Slot
6
4. Plug the adapter into a standard
jack on
LINE
5. Plug the modular cord's other end
power
DC
6. Fully extend the base's antenna
Mounting the Base
on a Wall Plate
1. Plug one end of the supplied short
AC outlet.
into a modular phone line jack.
and place it in a vertical position.
modular cord into the
LINE
the back of the base.
jack on