Philips VoIP 433 User Manual page 18

•
Reorient or relocate the receiving antenna ( that is, the antenna for radi or television that is
« receiving « the interference).
•
Reorient or relocate and increase the separation between the telecommmunications
equipment and receiving antenna.
•
Connect the telecommunications equipment into an outlet on a circuit different from that to
which the receiving antanna is connected.
If these measures do not eliminate the interference, please consult your dealer or an experienced
radio/television technician for additional suggestions. Also, the Federal Communications
Commission has prepared a helpful booklet, « How To Identify and Resolve Radio/TV Interference
Po\roblems. » This booklet is available from the U.S. Government Printing Office, Washington, D.C.
20402. Please specify stock number 004-000-00345-4 when ordering copies.
Noise
Electrical pulse noise is present at one time or another. This is most intense during electrical storms.
Certain kinds of electrical equipment, such as light dimmers, fluorescent bulbs, motors, fans, etc.,
also generate pulse noise. Because radio frequencies are susceptible to this, you may on occasion
hear pulse noise through the receiver. This is usually only a minor annoyance and should not be
interpreted as a defect of the unit.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minu\imum distance of 20
centimeters between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter. For hand held operation, this phone
has been tested and meets the FCC RF exposure guidelines. Use of other accessories may not
ensure compliance with FCC RF exposure guidelines.
Hearing Aid Compatibility (HAC)
This telephone system meets FCC and industry Canada standards for Hearing Aid Compatibility.
Privacy
Privacy of communications may not be ensured when using this telephone.
Additional Information
I.C. Notice
Terminal Equipment
NOTICE : This equipment meets the applicable Industry Canada Terminal Equipment Technical
Specificantions. This is confirmed by the registration number : the abbreviation, IC, before the
registration nubmer signifies that registration was performed based on a Declaration of Conformity
indicating that Industry Canada technical specifications were met. It does not imply that Industry
Canada approved the equipment.
NOTICE : The Ringer Equivalence Number (REN) for this terminal equipment is marked on the
equipment itself. The REN assigned to each terminal equipment provides an indication of the
maximum number of terminals allowed to be connected to a telephone interface. The termination on
an interface may consist of any combination of devices subject only to the requirement that the sum
of the Rigner Equivalence Numbers of all the devies does not exceed five.
Radio Equipment
The term « IC : » before the radio certification number only signifies that Industry Canada technical
specifications were met. Operation is subject to the following two conditions : (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Do not attempt to repair or modify this equipment
Repairs to certified equipment should be made by an authorized maintenance facility designated by
the supplier. Any repairs or alterations made by the user to the equipment may render the equipment
void in product warranty and compliance. This could also void the user's authority to operate the
equipment.
Service Centers
USA
Philips Consumer Electronics
P.O. Box 671539
Marietta, GA 30006-0026
Phone : 1-888-Philips (744-5477)
Phone : 1-800-363-7278 (English)
Phone : 1-800-661-6162 (Français)
CANADA
Philips – Consumer Service Division
4977 Levy Street
Ville st. Lurent,
Quebec H4R 2N9
Phone : 1-800-363-7278 (English)
Phone : 1-800-661-6162 (Français)