Table of Contents
Advertisement
to select DISPLAY. Press OK.
2.
Press Up or Down
to select LANGUAGE. Press OK.
3.
Press Up or Down
to select the preferred language. Press OK to save settings.
4.
Press Up or Down
Set dialing mode (Tone/Pulse)
Dialing mode applies only when you are making a telephone call. Your phone is by default set to tone
dialing. You can switch to pulse dialing if necessary.
Press MENU.
Press UP or DOWN
to select SETTINGS. Press OK.
Press UP or DOWN
to select DIAL MODE. Press OK.
Press UP or DOWN
to select TONE or PULSE dialing. Press OK to save.
Temporary tone dialing in pulse dial mode
If the dialing mode is set to pulse, you can press and hold the
during off hook. d will be displayed on the screen. All the following digits will be dialed as tones
until you hang up.
Flash duration
3.7.
Your phone comes with factory programmed flash durations. Check with your local telephone
company if you are not sure which duration to use.
1. Press MENU.
2. Press Up or Down
to select SETTINGS. Press OK.
3. Press Up or Down
to select FLASH. Press OK.
4. Press Up or Down
to select the desire flash duration. Press OK.
3.8.
Pause duration
Your phone comes with 2 factory programmed pause durations.
1. Press MENU.
2. Press Up or Down
to select SETTINGS. Press OK.
3. Press Up or Down
to select PAUSE. Press OK.
4. Press Up or Down
to select PAUSE 1 or PAUSE 2. Press OK.
Area code stripping
3.9.
This section is applicable to models with Area Code Stripping option only.
key to set temporary tone dialing
Area code stripping removes an area code as specified by you from any incoming caller id.
To activate and program the area code to be stripped:
1.
Press MENU.
2.
Press Up or Down to select SETTINGS. Press OK.
3.
Press Up or Down to select AREA CODE. Press OK.
4.
Press Left or Right to select ON.
5.
Press Down. Enter area code. Press OK to confirm.
Set display contrast
3.10.
1. Press MENU.
2. Press UP or DOWN
to select DISPLAY. Press OK.
3. Press UP or DOWN
to select CONTRAST. Press OK.
4. Press LEFT or RIGHT
to adjust the display contrast. Press OK to save the desire
settings.
Restore handset default settings
3.11.
You can reset the display, sounds, and other settings of your phone. Refer to the section Default
settings.
1. Press MENU.
2. Press UP or DOWN
to select SYSTEM and press OK.
3. Press UP or DOWN
to select RESET and press OK.
4. Press OK to confirm.
3.12.
Set Baby call on/off
Baby call allows you to dial out a programmed number via the telephone line by pressing any
key on the handset (except the OFF key).
1. Press MENU.
2. Select SETTINGS and press OK.
3. Select BABY CALL and press OK.
4. Press LEFT or RIGHT key
to select ON.
5. Press DOWN, Enter or edit the number.
6. Press OK to confirm. BABY CALL is displayed when you return to standby mode.
Advertisement
Table of Contents
